Personal Protection System RX - 400 Belt / Pocket Receiver OVERVIEW Each 'MINDA' RX-400 receiver can display two status indications from up to four different transmitter units, coded 1-4 and all operating with the same group code. Pressing the RED button on a 'key-fob' style transmitter should light the RED LED on the receiver, while the BLACK one lights the GREEN LED. 'BEEP' mode is selected by moving the On/Off switch in the direction away from the eight LED's and 'VIBRATE' mode is selected by moving the On/Off switch towards the eight LED's Briefly pressing the 'RESET' button will cancel any audible alert, initiate a 'lamp-test' and extinguish any LED's that may have been illuminated prior to resetting. Additional alerts provided: A Transmitter Low-Battery alert causes the appropriate LED indicator on the receiver to 'blink' out briefly about once per second. A Receiver jamming alert will cause a series of audible 'beeps' to be generated. If this occurs you should move to an interference-free location and as soon as the interference clears the 'beeps' will cease. OPERATION The receiver is very easy to use, and has two modes of operation, 'VIBRATE' and 'BEEP'. If the 'BEEP' mode is selected by moving the On/Off switch in the direction away from the eight LED's, when a 'wanted' signal is received the appropriate status LED will light and an audible pulsed tone alarm will be heard. The tempo of this pulsed tone is faster for a 'RED' alarm than for a 'GREEN' alarm, thereby facilitating the aural identification of 'Urgent' and 'Non-Urgent' transmissions. When 'VIBRATE' mode is selected by moving the On/Off switch towards the eight LED's, the appropriate LED will still light but all audible tone signals are inhibited. Silent signaling will be provided by means of a built-in vibrator. Whenever the receiver is initially switched on, all of the eight large LED's will be briefly illuminated, in pairs, to provide a 'lamp-test' and give visual confirmation that the microprocessor is operating correctly. The small red LED adjacent th the On/Off switch will then flash regularly as long as the receiver is operating but not receiving any signals. As soon as the receiver detects a signal the red LED will light continuously. Briefly pressing the 'Reset' button will cancel any audible alert, initiate a 'lamp-test' and extinguish any LED's that may have been illuminated prior to resetting SPECIFICATIONS Operating Frequency: Operating Range: Internal Power Source: Operating Temp. Range: 418.000 MHz nominal 150 to 450 feet (depends on local environment) 9 volt alkaline battery (MN-1604) -10 to +50 ° C Staying in control is simple, with Minda Contact your local sales rep for more details and ordering information! Or Email: sales@tacticaltechnologies.com